User`s manual

MyTek MWA-105 Access Point
Communication Ltd.
Version: 1.1
Refer to 4.10 What is Fragment Threshold?
RTS Threshold Set the RTS Threshold, value can be written between 0
and 2347 bytes.
Refer to 4.11 What is RTS(Request To Send) Threshold?
Beacon Interval Set the Beacon Interval, value can be written between 20
and 1024 ms.
Refer to 4.12 What is Beacon Interval?
Data Rate Select the transmission data rate from pull-down menu.
Data rate can be auto-select, 54M, 48M, 36M, 24M,
18M, 12M, 9M, 6M, 11M, 5.5M, 2M or 1Mbps.
Preamble Type Click to select the Long Preamble or Short Preamble
support on the wireless data packet transmission.
Refer to 4.13 What is Preamble Type?
Broadcast SSID Click to enable or disable the SSID broadcast function.
Refer to 4.14 What is SSID Broadcast?
IAPP Click to enable or disable the IAPP function.
Refer to 4.20 What is Inter-Access Point Protocol(IAPP)?
802.11g Protection Protect 802.11b user.
RF Output Power To adjust transmission power level.
Turbo Mode Click to enable/disable turbo mode.(Only apply to
WLAN IC of Realtek).
Block Rely Between
Clients
Click Enabled/Disabled to decide if blocking relay
packets between clients.
WMM Click Enabled/Disabled to init WMM feature
ACK Timeout Set the ACK-Timeout for a long distance link. The value
can be 0-255. A step is 4 us.
Apply Changes Click the Apply Changes button to complete the new
configuration setting.
Reset Click the Reset button to abort change and recover the
previous configuration setting.
3.3.6 Wireless - Security Setup
This page allows you setup the wireless security. Turn on WEP, WPA, WPA2 by using
encryption keys could prevent any unauthorized access to your wireless network.
MyTek Communication Ltd. Tel: [phone]
Vörösmarty utca 79. Budapest Fax: [phone]
Hungary H-1201 http://www.mytek.eu
18