Manual

Function Buttons

Two buttons, FN1 and FN2, are user programmable switches. Each

button's function is set inside the Function menu. The following

options are available (*PCM Only – not DSD):

Input - Allows the user to select 3 user “Presets,” Input A, Input B,

Input C; Each input can be assigned to either SPDIF, AES,

Toslink/ADAT, USB1, USB2, FireWire, Analog/SDIF or none. The

none allows to only switch between 2 Input presets.

Mute - Mutes the audio output.

Phase - Inverts the signals phase.

Mono - Sums left and right channel to mono.

L-R* - Subtracts one channel from the other, canceling out mono

information while leaving the stereo information.

Mid Side* - A combination of Mono (L+R) and L-R, the mid signal is

the sum of L and R (mono) and the side signal is the stereo

information from the L-R operation.

Dim Vol - Instantly lowers the level by 20dB.

Display

Brightness – Sets the brightness the LED display.

Meters - Turns the signal level meters on or off. (Available on black

panel versions only).

Auto-Off - This will turn the whole display off after selected amount

of time (secs). A dim dot will stay lit to show that the unit is

operational. Engaging any controls will wake up displays.

Remote

Enable - On and Off. Allows the Stereo192-DSD DAC to be

controlled by a Remote Control.

Mode - Select the remote type Apple or RC 5.

Adress Set – One time use of Apple remote ENTER button pairs the

remote with the DAC.

Fir mware

Version - Displays the current Firmware version.

Restore - Restores the unit's parameters to the factory default.