User Guide

PG 2
MyTana MS11-NG2 | MS11+ Combo | MS9-NG2 | MSA-NG2 User Manual
Damaged Connector Ends for NG connection style
If the camera head is disconnected
for transport or to swap heads
(using MS11+ Combo Kit), be sure
to carefully align the push rod with
the head and screw on until snug and there are no skipped
threads. Don’t over-tighten or use tools to tighten.
Damaged or Broken Connection Pins
uFor our older systems with pin connectors on the camera
head. We recommend keeping the head attached to the
push rod at all times to avoid accidental damage to the pins.
uFor our current PGR systems with a patch cord:
• Carefully align the patch cord to the Control
Box when connecting or you could break
the pins. Follow instructions included with
your system.
• The patch cord should NOT be disconnected from the
push rod reel. Check occasionally to make sure it is snug.
Broken Sapphire Window
The sapphire is nearly as hard as diamond;
however it can break with extreme impact,
especially on sharp edges of broken concrete
or clay tile. Using our IceBall, Snoball or other
protective guides greatly reduces impact to
the camera head.
Damaged Pushrod
The camera should not be forced through blockages. The
camera won’t work if the wires inside the push rod become
kinked, buckled or severed. Guides and running water can
help reduce friction as you push the camera through a pipe.
Warranty Information
Inspection Systems
All products are warranted against defects
in material and workmanship for one year from date of
purchase. All products are individually tested prior to
shipment. Damage due to negligence, abnormal usage,
accidents, or alteration is not covered by this warranty.
Examples of damage not covered by warranty:
Controls and Ports
CONTROL PANELS
Should repair be necessary, please call us
first so we can issue a return call tag.
Ship your product to:
MyTana 746 Selby Ave Saint Paul, MN 55106
phone: [phone]
POWER
Give the unit 30 seconds to
fully boot up (MyTana logo
will show when unit is ready
to operate)
Blinking Blue light indicates
low battery. It will blink for
5-10 minutes before battery fails.
TRANSMIT Generates 512hz
signal at camera head for use
with a Locator. This has nothing to do with Wi-Fi transmission.
LED CONTROL Full clockwise = full brightness
COUNTER RESET Resets on-screen footage
counter to zero
USB PORTS
Microphone
Ground Screw
can be used for grounding
purposes if needed.
Use these buttons for recording
and working with les, see
instructions on following pages.
The
arrow buttons are
frequently used, and are indicated
as in the instructions
Help prevent
repairs, see our
Care Tips
back cover