User's Manual

MYSPHERA • Ronda Auguste y Louis Lumiere 23, Nave 13 • 46980 Parque
Tecnológico de Valencia • Paterna, Valencia • Spain
Telf.: [phone] • [e-mail] • www.mysphera.com
Pág. 6
- Product identifier code:
o Start with 3 letters indicating type / family of the product.
o Followed by 2 letters indicating the type of interface and / or communication
of the product.
o Followed by 1 digit indicating version of the enclosures / enclosures /
mechanical encapsulation.
o Followed by 2 digits indicating the hardware version.
o Finishing with 2 digits that indicate the firmware version.
- IEEE adress: 12-digit alphanumeric MAC identification, unique for each device /
product manufactured.
- S / N: Serial number of the hardware used in that product.
o Internal product accounting code.
o Hardware manufacturing number.
- Electrical characteristics of use.
- Certification and marking symbols: CE and FCC
- Place and year of manufacture.
3. Instalation
The Bracelet Reader is a device with USB power. You need a USB cable type A-B to
connect to a computer.
To start using your Wristband Reader, connect the USB cable to the bottom of the reader,
as shown in the figure, allowing the cable to exit through the side hole. Connect the other
end of the cable to any USB port on the computer. The device will be detected by your
operating system and will be installed automatically, being ready for use. The blue indicator
light indicates that the device has been correctly installed.
Ilustration 2 – USB cable connection
To disconnect the Wireless Gateway simply disconnect the USB cable.