User's Manual
MYSPHERA • Ronda Auguste y Louis Lumiere 23, Nave 13 • 46980 Parque
Tecnológico de Valencia • Paterna, Valencia • Spain
Telf.: +34 96 182 71 77 • info@mysphera.com • www.mysphera.com
Pág. 9
8.3. Information about radiofrecuency
8.3.1. Radiolectric devices manufacturing
Cuadro Nacional Atribución Frecuencias (Spain, Orden ETU/416/2018, 26th April, 2018)
https://www.boe.es/diario_boe/txt.php?id=BOE-A-2018-5704
European Frequency Information System (
2402 MHz - 2480 MHz
)
https://www.efis.dk/views2/search-general.jsp
MYSPHERA declares that the radio equipment is manufactured so that it can operate in at
least one Member State without violating the requirements applicable to the use of the radio
spectrum in accordance with Article 10.2 of Directive 2014/53 / EU.
This device can be put into service and used without restrictions in several European Union
countries (BE / DE / ES / FR / GR / IT / NL / NO / UK)
9. Declaration of conformity
http://www.mysphera.com/declaration-of-conformity
9.1. CE Mark
MySPHERA declares that this device complies with the requirements and
specifications set out in Directive 2014/53 / EU (RED).
9.2. FCC Mark
This device complies with the Part 15 B specification of the FCC Rules.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.