Operating instructions

Place the hose into the filter cham-

ber (as shown), this will ensure the

water goes through the filter and

removes the air bubbles out of the

lines while you fill the system.

Place the hose into the filter cham-

ber (as shown), this will ensure the

water goes through the filter and

removes the air bubbles out of the

lines while you fill the system.

It is important that you fill your

spa with water to the proper lev-

el. The water level must be be-

tween 1” - 2” above the highest

jet. (as shown)

Filling You Spa Through the Filter

(Monaco Only)

Proper water level

The maintenance and care of your spa is simple and easy to carry out, and if performed regularly as

scheduled, problems will be minimal. It is important that the following procedures be read through and

carried out on a regular basis for the best, long term, overall performance of your spa.

The filtering cycle of your spa should be operated at least two hours or more a day (whether or not the

heater is heating) to remove impurities and to prevent disposition of contaminants in your spa. The filter-

ing system works automatically. Keep the spa covered when not in use to reduce the loss of heat and to

keep debris from settling in the water.

Maintaining the spa's proper water chemical balance is essential to the comfort and safety of the user.

Water mineral content varies constantly and is directly affected by evaporation and the use of cleaning

and maintenance chemicals, which will increase mineral content, when added. If the mineral content

deviates from prescribed pH level (7.2-7.8) deposits on the spa walls, filter, electric heating element or

gas heater manifold and piping may adversely affect the condition of your spa equipment.

SPA MAINTENANCE

SPA MAINTENANCE CONTINUED ON NEXT PAGE