Technical data

04
SLIM-LINE RC
5.0 Preparation
Before proceeding with the installation, unpack the carton
contents and check against the checklist below:
1. SLIM-LINE RC unit.
2. 15mm isolating valves (1 pair).
3. Instruction manual.
4. Warranty card.
5. Fixing kit (rubber mounts and cable gland).
6. Remote control handset.
6.0 Fixing
l Using the fixing dimensions (see fig. 1), mark the fixing hole
positions on the wall.
l Drill and plug the wall for No. 8 x 40mm round head wood
screws ensuring that the wall plugs are suitable for the wall
type.
l Remove the backing from the self-adhesive washers and place
on screws with adhesive side towards the point.
l Tighten the screws into the wall leaving about 9mm
projecting.
l Press adhesive washers to the wall.
l Remove outer case fixing screw at the bottom of the unit
(see fig. 2).
l Lift off outer case.
l Fit chassis on to retaining screws and tighten.
Fig. 1
23672 Slimline RC Manual 27/06/2011 09:30 Page 5