Instructions / Assembly

04
LO-LINE RC & LO-LINE RC Heater/Cooler
5.0 Preparation
Before proceeding with the installation, unpack the carton
contents and check against the checklist below:
1. LO-LINE or LO-LINE Heater/Cooler unit.
2. Instruction manual.
3. Fixing kit (rubber mounts and cable gland).
4. Remote control handset.
6.0 Fixing
l Using the fixing dimensions (see fig. 1), mark the fixing hole
positions on the wall.
l Plastic or metal anchors suitable for No.8 wood screws should
be used for mounting the convector to the wall.
l Remove the backing from the self-adhesive washers and place
on screws with adhesive side towards the point.
l Tighten the screws into the wall leaving about
3
/
8
inch
projecting.
l Press adhesive washers to the wall.
Remove the outer casing as follows:
l Remove the 2 screws from the underside of the unit (see fig. 2).
l Lift off the outer case.
l Fit chassis on to mounting screws and tighten.
Unit A B C
Dimensions (inches)
19-15 44
13
/
16
40
1
/
16
38
3
/
8
14-10 33
5
/
8
29
7
/
8
26
13
/
16
9-6 25
3
/
8
20
11
/
16
18
15
/
16
6-4 20
5
/
8
15
15
/
16
14
1
/
8
Cover Fixing Screws
Fig. 2 Case fixing screw positions
B
C
2 inches
A
2
7
/
16
2
1
/
4
min each
side
9
3
/
4
15
3
/
16
2
3
/
16
4
1
/
4
6 inches
Fig. 1
LO-LINE RC & LO-LINE RC HEATER/COOLER FAN CONVECTOR INSTALLATION, OPERATING, MAINTENANCE & AFTER SALES MANUAL - US 01.01.2015 ISSUE 4
28430 LoLine manual US WEB_Layout 1 28/01/2015 14:52 Page 5