Technical data

05
WHISPA III
®
5000, 7000 & 9000
04
WHISPA III
®
5000, 7000 & 9000
7.0 Water Connection
G Connect valve ends of the flexible pipes to the WHISPA III
®
.
Note: The direction of the arrows on the EZ flexible hosevalves
are not significant in this application.
G Open valves fully, check pipe connections for leaks and vent
the heat exchanger. A vent screw is provided to vent the heat
exchanger.
5.0 Preparation (continued...)
G A clean and level floor area is required under the cupboard
base.
G Floor mounting - WHISPA III
®
is normally fitted directly onto
the floor and the base of the unit is fitted with four mounting
feet.
G Decide the position of the WHISPA III
®
, mark out and cut the
plinth to the dimensions of Fig. 1 (floor mounting).
Model A B
Dimensions (in)
5000 18
3
/8 4
7000 20
1
/2 4
9000 22
5
/8 4
A
B
A = Width of cutout
B = Height of cutout
Note: unit dimensions given in Technical Data section 9.
Fig. 1 Plinth opening - floor mounting
6.0 Electrical Connection
G The electrical installation must comply with local or national
wiring regulations.
G This unit is supplied fitted with 8ft of 18awg cord with plug.
WARNING: This appliance must be grounded.
Do not energize the electrical supply until the remaining stages of the installation have been completed.
WALL
WALL
Isolating valves
Air vent screw
Flexible pipes
Pipework must be positioned correctly to ensure flexible hoses are not kinked when installed. See Fig. 2.
Fig. 2a Left hand view - suggestion only
Fig. 3
Fig. 4
Fig. 2b Right hand view - suggestion only
6.0
7.0
For ease of installation and maintenance WHISPA III
®
units should be installed with flexible hoses, with integral isolating valves.
Flexible hoses are supplied only with the WHISPA III
®
EZ units.
12"
16"
10"
4"
5.0
21475 Whispa Manual - US:Layout 1 8/5/09 09:34 Page 5