Technical data
Model
20° 30° 40° 50° 60° 20° 30° 40° 50° 60°
500
Normal 393 566 733 896 1056 1340 1930 2501 3057 3603
Boost 447 683 923 1166 1412 1524 2331 3150 3980 4817
600
Normal 467 729 1000 1278 1562 1592 2486 3412 4361 5330
Boost 607 939 1279 1625 1977 2072 3203 4363 5545 6744
800
Normal 747 1077 1396 1707 2012 2550 3675 4763 5824 6864
Boost 845 1289 1738 2192 2649 2885 4397 5930 7478 9039
600 - 12V
Normal 467 729 1000 1278 1562 1592 2486 3412 4361 5330
Boost 607 939 1279 1625 1977 2072 3203 4363 5545 6744
Heat Output (Watts) Heat Output (Btu/h)
Heating Performance Data
Temperature Difference (°C)
Fan
Speed
09
KICKSPACE
®
500, 600, 600-12V & 800
10.0 Technical Data (continued...)
Sound Levels
Heat outputs tested in accordance with
BS 4856 Part 1.
Flow Rate: 340 ltr/h (75 gal/h).
Flow Rate Correction Factors:
455 ltr/h (100 gal/h) multiply output by 1.03.
227 ltr/h (50 gal/h) multiply output by 0.96.
113 ltr/h (25 gal/h) multiply output by 0.85.
Sound levels tested in accordance with EN 23741.
*Includes transformer.
Model
Sound Pressures at 2.5m (dBA)
500 25.7 38.1
600 26.4 37.2
600-12V 26.4 32.7
800 28.5 49.8
Normal Boost
Weight, Water Content and Motor Power
Model
Motor
Power (W)
Water
Content (l)
Unit Weight
(kg)
500 25 0.26 4.3
600 40 0.30 5.0
600-12V 40 0.30 7.9
800 40 0.34 5.5
Approximate Hydraulic Resistance through Fan Convectors
Litres/h
500
788
488
231
82
600
1046
625
326
95
600-12V
1046
625
326
95
800
911
544
258
82
500
7.7
4.8
2.3
0.8
600
10.3
6.1
3.2
0.9
600-12V
10.3
6.1
3.2
0.9
800
8.9
5.3
2.5
0.8
455
340
227
113
mm wg
kPa
*
11.0 Operating Instructions
This unit is controlled by the switches on the front of the unit, or
by means of the wall mounted remote switching kit if fitted.
Ensure the electricity supply is switched on.
Heating Mode
The fan will only operate when
• The central heating boiler is on
• The pump is running
• The system water temperature is greater than 32°C.
Ensure boiler is on, and set timer, boiler controls and room
thermostats as necessary.
• Turn room thermostat to a high setting.
• Set summer - winter switch to
• Set fan speed control to position I.
• The unit will now run on low fan speed.
Performance will depend on the water temperature at the coil
and the flow through the coil.
Temperature Control
The room thermostat setting should be gradually adjusted to
obtain the desired temperature.
The fan speed can be set to boost by switching the fan speed
switch to II.
A low speed setting is recommended for normal operation with
the higher speeds for boost heating when required.
Low Limit Operation
The low limit thermostat fitted to the KICKSPACE
®
will ensure
that the fan stops after the heating system is switched off and
the water flow stops. If left in an operating position the unit will
automatically restart when the heating system is reheated.
Off Position
Set the fan speed selector switch to the off (O) position.
Summer Mode
If required, the KICKSPACE
®
can be used in Summer for air
circulation without heat.
Set summer - winter switch to
Adjust fan speed to required setting.
If a remote control switch is fitted, the fan switch on
the unit will be inoperative. Refer to the instructions
supplied with the remote control switch for details.
9.0
10.0
11.0
KICKSPACE 500, 600, 600-12V & 800 INSTALLATION & MAINTENANCE MANUAL
01.01.2013 ISSUE 6
26690 Kickspace Manual for web_Layout 1 24/09/2013 10:08 Page 10