Quick Start Guide

iVECTOR Quick Start Guide
iVECTOR Quick Start Guide
1.0 Introduction
The electronic control system on the iVECTOR provides a wide range of options that can
be selected according to system complexity and operating requirements.
Each iVECTOR leaves the factory with its controls set to the simplest level (easy mode).
This setting allows you to set the time, set the temperature via the comfort setting as well
as selecting your required fan speed.
3.0 Operation
Comfort Setting:
The iVECTOR will run indefinitely in this setting,
providing the water temperature is greater than
32°C heating, less than 15°C cooling. The fan
speed will automatically switch depending on
the difference between the room temperature
and the required set temperature.
Use the (+) and (-) keys to set your desired
temperature, followed by (OK) to confirm.
(Default setting is 21°C).
Setting Fixed Fan Speed Function:
Selecting one of these options provides fan only operation with no temperature control.
Using the (+) and (-) keys select F1, F2, or F3 for your desired fan speed (F1 being
the lowest fan speed and F3 the highest), followed by (OK) to confirm.
Setting Clock and Day Function:
Using the (<) and (>) keys tab across to to allow you to set the clock and/or day
function then press (OK) to change the time.
To set the minutes use the (+) and (-) keys, followed by (OK) to confirm.
To set the hours use the (+) and (-) keys, followed by (OK) to confirm.
To set the day use the (+) and (-) keys, followed by (OK) to confirm.
Power On/Off Function:
Using the (<) and (>) keys tab across to to allow you to use this function then press
(OK) to either turn the unit on or off.
Use the (<) and (>) keys to navigate the following
options, the function is highlighted when
a appears over the icon:
1. Heating symbol
2. Cooling symbol
3. Temperature symbol - when
this is displayed the current room
temperature is displayed
4. Room temperature
5. Fan speed symbol (fan blades will
rotate when active)
6. Day of week
7. Time
8. Comfort setting
9. Power (on/off)
10. Clock setting
11. Square indicator highlights
selected function.
2.0 Display
5
1
2
4
3
6
7
811 9 10
1 2 3 4 5 6 7
20.6
16:09
°C
24160 iVector Control Guide A5 21/10/2011 09:24 Page 3