Instructions / Assembly

10
iVECTOR Heater/Cooler
9.0 Electrical Connection
WARNING: This appliance must be grounded. The electrical installation must comply with state or local codes.
l The electrical installation of this appliance should be carried
out by a qualified electrician in accordance with current
regulations.
l This unit is supplied with factory fitted 3 core cord, 6ft in
length with moulded plug.
For Building Management System
l Connect wires from BMS and valves as necessary, using the
same cable routing into the control box, and with the cable
gland supplied.
1. Remove x 2 screws to access control panel 2. Remove control panel cover
25278 iVector Installation Guide US 02/01/2013 09:25 Page 11