User's Manual

第 4 頁，共 4 頁
3-4-1. Please short press the HI / LO button to leave the channel setting mode.
3-4-2. Please follow the relevant setting procedures to change the channel settings at the receiver. (Change the
same channel setting as the microphone)
3-5. With ACP automatic frequency pairing function, after the channel change and adjustment is completed, follow
the steps below:
3-5-1. Please press the Pair button on the receiving end, the RF light will light up once (indicating that the
channel pairing has been received).
3-5-2. Please short press the HI / LO button, the channel setting is completed. (The RF light on the receiving
end is always on)
※ ACP : Automatic Channel Pairing
※ Radio waves are easily interfered by the environment and surrounding radio waves. If you find that there is
interference, please change the channel to improve this phenomenon.
4. Instructions for battery replacement:
4-1. The battery uses AA batteries x2. (It is recommended to use alkaline batteries).
4-2. Please take out the battery and store it if it will not be used for a long time to avoid product damage caused by
battery leakage.
4-3. When the battery power is low, please replace the battery immediately when the battery has no number of
cells.
4-4. When replacing the battery, please turn the battery tube body by hand and put the battery in the marked
position (as shown on the left).
5. Instructions for use:
Operating voltage 1.5V / AA alkaline battery (Alkaline) x2
Transmission distance
The transmission distance is up to 10 meters indoors and outdoors, which will vary
according to the environment.
(Tested with straight line distance)
Environmental
Requirements
ꞏOperating temperature/humidity: 0°C - 40°C / 10% - 90% RH non-condensing
ꞏStorage temperature/humidity: -10ºC - 70ºC / 5% - 90% RH non-condensing.
※ Do not cover the antenna position with human body, hand, metal or other objects to avoid poor reception.