User's Manual

第 3 頁，共 4 頁
1. Product appearance and function description:
2. Operating Instructions:
2-1. Power on: Press the function key for 1 second (press down in the middle), and the display window will light up
to power on.
2-2. Power off: press the function key for 1 second (press down in the middle), the display window will turn off and
the power will be off.
2-3. Volume adjustment (music): the function key increases the volume up and down the volume decreases. (Host
music volume adjustment)
2-4. Volume adjustment (microphone): the function key increases the volume to the right and decreases the volume
to the left. (Host microphone volume adjustment)
2-5. Microphone mode adjustment: Short press the function key (middle) to switch the mode. (This function is
valid only when the host side setting is enabled)
Switching order: BeginnerProSuperstarBroadcastCustomBeginner (loop).
2-6. Power adjustment: Short press the HI / LO button (inside the battery tube) to switch the transmit power.
2-6-1. HI : The transmit power is higher and consumes more power. Please use it according to the usage
environment. (within low power specification)
2-6-2. LO : The transmit power is lower, saving power (default). (within low power specification)
2-7. Channel setting: Press and hold the HI / LO button (inside the battery tube) for ≧3 seconds, the display
window will flash, and enter the channel setting mode.
mode (please follow the instructions in 3. Channel setting mode operation).
3. Instructions for channel setting mode:
3-1. Setting mode: After turning away the hand holding the battery tube, press and hold the HI / LO button for ≧
3 seconds, and the display window will flash to enter.
3-2. Channel setting: Decrease the function key to the left or increase the channel CH01~CH32 to the right. (A/B
group channels can be the same)
3-3. A / B group setting: Use the function key to select A group up and down to select B group. (Two microphones
cannot be in the same group)
3-4. Without ACP automatic frequency pairing function, after the channel change and adjustment is completed,
follow the steps below: (If you have ACP, please skip to 3-5)