Use and Care Manual
Table Of Contents
- In the Box • What You’ll Need • Compatibility
- High Voltage Warning!
- Getting Started • Install App
- Getting Started • Warning
- Setup • 240V
- Setup • 120V
- Setup • Using Wire Nuts
- Setup • Secure Mysa
- Setup • Adding a Thermostat
- Support • Symbols & Codes
- Support • Troubleshooting
- Legal & Warranty
- Dans la boîte • Ce dont vous aurez besoin • La compatibilité
- Avertissement !
- Démarrage • Télécharger l’application
- Démarrage • Avertissement !
- Installer • 240V
- Installer • 120V
- Installer • Utiliser les écrous de fil
- Installer • Attacher Mysa
- Installer • Ajouter un thermostat
- Assistance • Symboles et Codes
- Assistance • Dépannage
- La loi et la garantie
7
EN
Getting Started • Warning
Turn off power at the circuit breaker that controls your
existing thermostat.
Double Check - After you turn off the breaker confirm
the heater is off by doing the following:
- Turn the thermostat all the way up.
- Wait 510 minutes.
- Put your hand near the heater. Make sure no heat
is coming through. If you have multiple heaters check
each separately. If you are unsure if the power to your
heater is off, please contact a licensed electrician.
Remove your existing thermostat. Only proceed with the installation
if there are wire nuts connecting the thermostat wiring.
2
3