Use and Care Manual
Table Of Contents
- In the Box • What You’ll Need • Compatibility
- High Voltage Warning!
- Getting Started • Install App
- Getting Started • Warning
- Setup • 240V
- Setup • 120V
- Setup • Using Wire Nuts
- Setup • Secure Mysa
- Setup • Adding a Thermostat
- Support • Symbols & Codes
- Support • Troubleshooting
- Legal & Warranty
- Dans la boîte • Ce dont vous aurez besoin • La compatibilité
- Avertissement !
- Démarrage • Télécharger l’application
- Démarrage • Avertissement !
- Installer • 240V
- Installer • 120V
- Installer • Utiliser les écrous de fil
- Installer • Attacher Mysa
- Installer • Ajouter un thermostat
- Assistance • Symboles et Codes
- Assistance • Dépannage
- La loi et la garantie
EN
20
Legal & Warranty
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications that are not expressly approved by the manufacturer could void the user’s
authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In
order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the
antenna shall not be less than 8 inches during normal operation.
Industry Canada IC Compliance Notice
This device complies with Industry Canada license-exempt RSS standard(s).