Use and Care Manual
Table Of Contents
- In the Box • What You’ll Need • Compatibility
- High Voltage Warning!
- Getting Started • Install App
- Getting Started • Warning
- Setup • 240V
- Setup • 120V
- Setup • Using Wire Nuts
- Setup • Secure Mysa
- Setup • Adding a Thermostat
- Support • Symbols & Codes
- Support • Troubleshooting
- Legal & Warranty
- Dans la boîte • Ce dont vous aurez besoin • La compatibilité
- Avertissement !
- Démarrage • Télécharger l’application
- Démarrage • Avertissement !
- Installer • 240V
- Installer • 120V
- Installer • Utiliser les écrous de fil
- Installer • Attacher Mysa
- Installer • Ajouter un thermostat
- Assistance • Symboles et Codes
- Assistance • Dépannage
- La loi et la garantie
17
EN
Support • Symbols & Codes
Welcome
You’ll see Mysa smile on startup
or after successful pairing.
Software Update
That spinning rectangle means
Mysa is getting a software
update from us over the internet.
Settings Change
Check! This will pop up when you
change your settings from the app.
Error Codes
Error codes have a
LETTER/NUMBER
format (A1, Z4, B5).
Example:
H2 - Mysa did not
detect a heater load.
If you see this, contact
support on pg 18 with
the specific code shown
on Mysa’s display.
Pairing Mode
The arrow means Mysa is ready
to begin the pairing process.