Z-Series Z 3 5 0 I n te gr a t e d A m p l i f i e r Owner’s manual www.myryad.co.
CONTENTS • • • • • • • • • • Introduction Installation and Safety Accessories Setting up your Ampligier Rear panel connections Operating your Ampligier Front panel controls Remote Control Loudspeaker Output Protection and Muting Installing and replacing batteries in the remote control Trouble-shooting guide Specifications 2 2 2 3 4 5 6 7 7 7 INTRODUCTION INSTALLATION AND SAFETY The Myryad Z350 Integrated Amplifiers have been designed to deliver a combination of high quality sound reproduction and elega
SETTING UP YOUR AMPLIFIER XLR R L www.myryad.co.uk BT ANT RIGHT SPEAKERS LEFT DESIGNED IN ENGLAND BY MYRYAD SYSTEMS LTD MADE IN CHINA OFF ON POWER CD USB DAC OPTICAL SACD TAPE AUX BYPASS PER OUT L L R R MINIMUM SPEAKER IMPEDANCE 4 MINIMUM IMPEDANCE DES HAUT PARLEURS 4 COAXIAL POWER RATING DIGITAL INPUT 15 14 13 USE ONLY WITH A 250V FUSE 400W 230V 50/60Hz FUSE: T6.3AL /250V S/N 12 11 10 9 8 7 6 5 4 3 2 1 REAR PANEL CONNECTIONS 1.
OPERATING YOUR AMPLIFIER MUTE PHONES SOURCE 350 4 5 2 1 3 6 7 FRONT PANEL CONTROLS and q 5. Source select p These buttons scroll up or down through the inputs to select the source you wish to listen to. The display shows which input has been selected. 1. Standby When the amplifier is plugged into a live wall socket and the POWER switch is turned ON, it will power up in “standby” mode and the LED (Light Emitting Diode) in the display will glow red.
REMOTE CONTROL MUTE Mute on integrated amplifier DIMMER DIMMER MUTE TUNING Screen On/Off MEM Scan back Random play Scan forward PRESET FREQ Skip back to previous chapter Repeat Chapter/Title/Disc Skip forward to next chapter Stop BAND ENTER Play/Pause MENU Navigate and select from OK SOURCE Device mode shift button (placing at AMP position) Confirms/Selects item.
LOUDSPEAKER OUTPUT PROTECTION AND MUTING amplifier overheating, amplifier DC fault) the loudspeakers will be disconnected from the amplifier to protect both. In the case of a short circuit or DC fault the loudspeakers will be re-connected after a few seconds, but will be disconnected again if the fault persists.
INSTALLING AND REPLACING BATTERIES The batteries should always be removed if they are discharged (indicated by no remote control operation or by operation only at very short range), or if the remote control is not going to be used for an extended period. The remote handset uses two 1.5 V type AAA batteries. To fit new batteries first open the battery compartment at the base of the handset and remove any existing batteries.
www.myryad.co.uk Myryad Systems Ltd. Our policy is one of continuous product improvement, we reserve the right to change the designs and specifications without notice. All information is given in good faith. The manufacturer accepts no responsibility for errors, omissions or incorrect assumptions. This symbol means do not dispose of as municipal waste. Re-use or recycle wherever possible. Electrical/Electronic Equipment may contain substances harmful to the environment.
