Operating Instructions

SENSE MCE IBC Operating Instruction
Rev. D, 2020-12-15 Release Page 33 of 46
© MYNXG Product GmbH, 2020. All rights reserved
5.3.1 LTE and WCDMA Operating Bands
The following LTE / 3G bands might be used for the operation of the Sense MCE IBC. Some
of the bands are optional, other will be supported always. Operational bands in North Americ2
are marked BOLD in Table 3:
Table 3: Operating bands.
Operatin
g Band
Description
Mode
Tx (MHz)
Rx (MHz)
Band 2
PCS 1900MHz
LTE FDD / WCDMA
1850 - 1910
1930 - 1990
Band 4
AWS-1 1700MHz
LTE FDD / WCDMA
1710 - 1755
2110 - 2155
Band 5
CLR 850MHz
LTE FDD / WCDMA
824 - 849
869 - 894
Band 12
LSMH (Blocks A/B/C)
LTE FDD
699 - 716
729 - 746
Band 13
USMH (Block C)
LTE FDD
777 - 787
746 - 756
Band 17
LSMH (Blocks B/C)
LTE FDD
704 - 716
734 - 746
Band 66
Extended AWS-1
(Blocks A-I)
LTE FDD
1710 - 1780
2110 - 2200
Band 71
US 600
LTE FDD
663 – 698
617 - 652
5.3.2 LTE and WCDMA Receiver Sensitivity
For the receiver performance of the LTE Module are the conducted receive sensitivity and the
conducted transmit power important parameters. Receiver sensitivity is the lowest power
level at which the receiver can detect an RF signal and demodulate data. The typical values
are listed below in Table 4.
Table 4: Conducted Rx sensitivity.
Mode
Band
3GPP
Requirement
(dBm)
Rx Sensitivity
(dBm) Typical
Note
WCDMA
Band II
-106.7
-109.0
BER < 0.1%
Band IV
-106.7
-109.5
BER < 0.1%
Band V
-104.7
-111.0
BER < 0.1%
LTE FDD
Band 2
-94.3
-97.8
10MHz Bandwidth
Band 4
-96.3
-97.8
10MHz Bandwidth
Band 5
-94.3
-99.0
10MHz Bandwidth
Band 12
-93.3
-98.0
10MHz Bandwidth
Band 13
-93.3
-97.0
10MHz Bandwidth
Band 17
-93.3
-98.0
10MHz Bandwidth
Band 66
-95.8
-97.8
10MHz Bandwidth
Band 71
-93.3
-98.0
10MHz Bandwidth