Operating Instruction

EDGE FCR 3 Operating Instruction

Page 30 of 64 Release Rev. C, 2019-09-10

3.5 Antennas

Per default the MYNXG EDGE FCR 3 Industrial Gateway is delivered with already pre-

assembled antennas. Nevertheless, it might be necessary to dismount and remount the

antennas during the hardware installation for some reasons. This can be done by turning the

ring on the antenna socket counterclockwise, installation of the antenna is done in the

opposite way. The EDGE FCR 3 is equipped by two different antenna types as shown below.

Figure 18: Antennas for LTE and Sub-1GHz networks with SMA Male connector

Figure 19: Wi-Fi “Rowing Stick” antenna with RP-SMA female connector

CAUTION

Please note: The LTE antennas have a SMA MALE connector and shall

not be place on MALE sockets (Figure 18).

CAUTION

Please note: The Wi-Fi antennas have a RP-SMA FEMALE MALE

connector and shall not be place on FEMALE sockets (Figure 19).

CAUTION

Due to the high-power output of the sub-1GHz antennas (up to +19dpm),

the respective sensors should be placed at a certain distance (> 2m) from

the EDGE FCR 3 to ensure a proper operation until the output power has

been reduced.

Male

Female