Operating Instruction

EDGE FCR 3 Operating Instruction

Rev. C, 2019-09-10 Release Page 3 of 64

Notice

These operating instructions are an integral part of the EDGE FCR 3 system and should always

be kept at hand. Observance of the instructions given within this manual is required for proper

performance and correct operation of EDGE FCR 3.

The EDGE FCR 3 and its accessories must not be used for any other purpose than described

in the accompanying documentation (intended use). Violation will result in loss of warranty.

MYNXG Product GmbH does not accept liability for injury to personnel or damage to

equipment that may result from misuse of this equipment, failure to observe the hazard

notices contained in this manual, or failure to observe local health and safety regulations.

MYNXG Product GmbH shall be under no circumstances liable for incidental or coincidental

damage arising from use of the equipment described in this document.

No part of the accompanying documentation may be translated or reproduced without written

permission of MYNXG Product GmbH, unless reproduction is carried out for the sole purpose

to be used by several people in the same department.

The user must treat the accompanying documentation like any other copyrighted material.

Especially, if part of the accompanying documentation is provided in electronic form, these

files shall not be modified in any way. MYNXG Product GmbH and its suppliers retain title and

all ownership rights to the accompanying documentation (in either electronic or printed form).

MYNXG Product GmbH

Friedhofstrasse 72

DE-63263 Neu-Isenburg

Germany

www.mynxg.com

Last update: 10 September 2019