Operating Instruction

EDGE FCR 3 Operating Instruction
Page 28 of 64 Release Rev. C, 2019-09-10
© MYNXG Product GmbH, 2019. All rights reserved
3.4 Placing the EDGE FCR 3
The EDGE FCR 3 industrial gateway is designed for indoor applications and should be placed
with a minimum distance of 250cm between ground floor and lower device corner for a good
radio performance (Figure 16). It can also be placed inside an electrical switch cabinet
(without metal housing).
Figure 16: Mounting height of MYNXG EDGE FCR 3
WARNING
The EDGE FCR 3 is not designed / intended to be used within ATEX areas
or hazardous environments.
WARNING
The EDGE FCR 3 is not designed / intended to be installed outside
buildings, in dusty environments and / or areas with high humidity /
temperature changes.
CAUTION
The EDGE FCR 3 shall not be installed on a place where it might be
penetrated by mechanical stress.
≥ 250cm (10 inch)