Owner`s manual

21
Master Equalizer
The Master Equalizer is a stereo 4-band fully parametric EQ designed to fine tune the output of
your myMix to the device through which you are monitoring. Each of the four bands has
adjustable frequency, Q (a measure for bandwidth of the filter, where the higher the Q is, the
more narrow the filter gets, and the lower the Q is, the wider the filter gets) and Gain.
The Low and High frequencies can also be
configured as shelving filters. Bypass
removes the Master Equalizer from the audio
path yet retains your settings to quickly
compare between the original and equalized
versions. The setting of the master eq is saved
in the current profile.
One global effect can be selected for each
myMix unit. There is a choice of seven
different effects from which to choose: three
room reverbs, three hall reverbs or delay with
adjustable delay time (10ms to 350ms) and
repeats. Default setting for the Effect type is:
Large Room
Effects
Local Inputs/Outputs
Turning the function „Send Mix to Network“ on, is sending the stereo mix of that myMix to the
network allowing other myMix devices to select this mix as an input channel. The signal will show
on the network with the device name and the appendix „Mix“. This function is independent of the
input mode of the local inputs. If you have selected other mixes in the Remote Channel Select
menu, they will be deselected when you turn „Send Mix to Network“ on. If you stay in the same
profile, they will be reassigned as soon as you turn your mix off.
Note: when „Send Mix to Network“ is ON, it is not possible to select a mix from another myMix on
the network, in order to prevent a possible fedback loop.