Owner`s manual

Send Mix to Network: Off

Local Inputs/Outputs

The Local Inputs/Outputs screen allows you to activate phantom power, select input modes,

name your inputs and decide if you want to send your mix to the network. Phantom power is

available and is switchable ON or OFF for both inputs. When phantom power is activated, an

icon appears in the status bar. It is recommended to turn phantom power OFF when it is not

required by an input device.

myMix has four Input Modes:

DUAL MONO – Select dual mono for two independent sources such as guitar and vocal. Dual

mono inputs appear as two separate channels on all myMix units.

MONO - enables only input 1, input 2 is not activated. It will not show up on the mix screen. This

mode is to save space on the screen and recording capacity on the SD card. However a single

mono channel uses the same networking capacity as a dual mono, or a stereo channel. (also see

SETTINGS-Remote Channel Select).

STEREO – Select stereo when using a stereo source such as a keyboard, mp3 player, or

electronic drums. In stereo mode, inputs 1 and 2 are routed 100% to the left and right sides,

respectively. A stereo input is displayed as a single channel on all myMix units, yet contains left

and right signals.

NONE – Select that input mode if you are not using any of your local myMix inputs at all.

Because there are no inputs from your device on the network, your unit will not show up for

others. If you want to use your inputs but you can't see them on the main screen, check the input

mode setting.

The input modes and channel names are automatically stored in your current profile. If you

change them the audio setting (volume, etc.) on all devices will go back to “Zero Mix”, as it does

with every new device on the network.