Owner`s manual

Volume
The default view on the CHANNEL screen is the volume control. The jog wheel adjusts channel
volume from 0% to 100%. The default volume is 0%.
Tone
While on the CHANNEL screen, push the soft key labeled TONE to adjust simple Bass and
Treble controls with the jog wheel. The default position is center.
Effect
Push the soft key labeled EFFECT to increase or decrease the amount of internal effect applied
to each channel (the type of effect is selected in the EFFECTS screen under SETTINGS, if you
have selected the effects type: none, no effect will be audible). The default position is 0% .
Pan
By pushing the soft key labeled PAN, you can control where the signal appears in the stereo
field. Panning signlas in combination with adding some individual roomm effects is crucial to
achieve a natural 3D sound image. Leaving all signals in the center (mono mix) will result in a
one dimensional sound with little differentiation between the signals.
Keep in mind that if you are listening on a mono
device, panning a mono signal fully to the
unused output will make the signal disappear.
This also applies to stereo signals as they
default to 100% left and 100% right. The
default position is center.
For a stereo signal, the panorama turns into a
BALANCE control. Each individual channel of
a stereo signal is routed 100% to the left or
right by default. BALANCE allows you to move
the stereo image to either side.
18