Owner`s manual

6/12

Mute

To MUTE a channel, scroll to the channel so it is highlighted and push the soft key labeled MUTE.

Channels with the MUTE function activated are completely silenced. Multiple channels can be in

MUTE mode simultaneously.

A red MUTE indicator will appear on the

channels that are in MUTE mode. Additionally,

a MUTE indicator will appear in the status bar.

Push the MUTE soft key again to clear the

channel MUTE. Pushing and holding the

MUTE button for more than three seconds

clears MUTE for all channels.

To MUTE all channels immediately, press the master MUTE button on the control surface [3]. If

the master MUTE button is activated it will turn red. Pressing it again will un-MUTE the master

output. „Send Mix to Network“ is not muted with this button.

Status Bar

The status bar provides information about several different aspects of myMix operation. The

actual display depends on the situation.

Left to right: network connection with POE, unit name and active profile. SD card inserted, red dot indicates

recording, the time is the remaining time on the SD card, phantom power enabled. The channel counter

shows 6 selected channels from a total of 12 on the network. One or more channels muted and soloed.

CHANNEL SCREEN

Whenever you select a channel (e.g. Kick Drum) and press the jog wheel [4], you open up the

Channel Screen. Here you can adjust the selected audio channel in volume and tone, add

effects or adjust the panorama/balance in the stereo mix. To return to the MAIN screen, either

push the jog wheel again, or allow the screen to time out (see also under SETTINGS-

Preferences-Activity Time Out).