Owner`s manual

Power

Supply

Outputs

While there is usually no harm in connecting a headphone to the ¼ “output jacks, keep in mind

that you will only be hearing either the left or right side of your mix. See back of the manual for

detailed specifications and pin out.

CAUTION: Before you connect to an amplifier or powered

loudspeaker, make sure they are switched off and turned down to

avoid equipment damage

WARNING: Excessive sound pressure level on ear-plugs,

headphones or loudspeakers can damage your hearing and

cause hearing loss! Before you connect a headphone or in.ear

monitor press the master mute button. Connect them before you

put them to your ears and check for SPL.

Power

myMix can be powered using the included external power supply, or by a POE (Power Over

Ethernet) equipped Ethernet switch. Keep in mind that each myMix unit requires 15 watts, so

choose a POE switch that has a POE budget that is capable of powering all units on the

network. 60 Watts of POE will power 4 myMix units, to power 8 myMix units you need a

minimum POE budget of 120 Watts.

Three units connected to a switch, two using POE (30W) and one with external power supply.