Installation guide

Installation
Manual No. DB11-000033-00 2-11
5. Connect the SCSI cables from the internal disk drives to the SCSI
connector on the eXtremeRAID 3000 controller, as shown in
Figure 2-8. (The controller is already connected to the system board.) If
necessary, refer to Table 2-2 on page 13 for SCSI formats and bus
lengths.
Figure 2-8. eXtremeRAID 3000 SCSI Termination Example
☛ Note
In order to ensure an error free environment, the
proper cable type designed for a certain SCSI
speed must be used.
☛ Note
The internal SCSI channel on the eXtremeRAID 3000
is designed to handle internal disk drives and other
devices such as a CD-ROM drive or a tape drive.