Installation guide

Performing an Installation

2 eXtremeRAID DAC1164P Quick Installation Guide

Figure 1. eXtremeRAID with Component Locations

Installing the eXtremeRAID into the System Board

1. With the power off, plug the eXtremeRAID card into an available 32-

bit or 64-bit PCI slot (refer to Figure 2).

Table 1. Jumper and Connector Descriptions

Jumper Description Default Setting

JP1 serial port connector –

JP2 pins 1–2 for Arm Proc, pins 2–3 for I

O1–2

JP3 pins 1–2 normal , pins 2–3 blank ROM mode 1–2

JP5 must be installed on

JP6 maintenance – do not use off

JP7 ROM emulator – do not use off

JP8 Mylex manufacturing diagnostics – do not use off