Installation guide

Modifying Physical Device Options
4-34 GAM Client v3.00 and WSAM User’s Manual
• Enable (by checking) or disable (by unchecking) the following SCSI
Device Parameters:
• Wide Negotiation. Allows the controller to negotiate at wide data
transfer rates.
• Disconnect. Allows the target to disconnect from the initiator.
• Change the SCSI ID of this HBA.
• Change either of the following Startup Parameters:
• Spin-up. No Spin up, Controller spin up.
• Delay. Number of seconds before physical device startup.
• Change the following SCSI Device Parameter:
• Maximum data transfer rate of the disk side channels. Speeds are
Asynchronous, 5 MHz, 10 MHz, and 20 MHz.
Click the OK button to accept the changes, or the Cancel button to discard
them.
Modifying Physical Device Options
Open Physical Device Options as shown in Figure 4-29:
Figure 4-29. Select “Physical Device Options”