Installation guide

Setting and Modifying User Preferences
4-16 GAM Client v3.00 and WSAM User’s Manual
The Launch Application setup box is displayed as shown in
Figure 4-18:
Figure 4-18. Launch Application Setup Dialog Box
3. In the Launch Application box:
• Enable or disable this Application entry using the Enabled check
box.
• Enable Launch Only Once if you want to prevent the application
from launching again if GAM detects that it is already running.
• Enter the name of an application to launch should certain events or
messages require it.
• If you don’t remember the name or path of the application, click the
Browse button.
4. To test the application launch using the settings you’ve input, click
Test.
5. When you are satisfied with the application you’ve set up, click OK.
Your new application entry appears in the lower window of the Alarm
Setup dialog box. (Refer back to Figure 4-17 for an example.)
Remove an Application to Launch
1. Select the Launch Application alarm type in the upper window of
Alarm Setup.
2. Select the Launch Application entry to remove in the lower window of
Alarm Setup.
3. Click Remove.