Installation guide

Error Codes
Manual No. 771961 A-7
20—StartDev01 New drive state is DEAD
21—StartDev02 Standby rebuild bit set
22—StartDev03 State is DEAD
23—StartDev04 Failed
30—BusReset01 Bus reset did not clear (dead channel)
31—BusReset02 Bus reset did not clear
40—MaxConsecBusy Max consecutive busy status count exceeded
41—DoubleCc Check condition status on request sense command
42—MaxSelTimeout Max consecutive selection timeout count exceeded
43—CcDeferred Check condition with sense data deferred error
44—MaxPerr Max consecutive/accumulated parity error count
exceeded
45—MaxResCnflct Max consecutive reservation conflict status count
exceeded
46—MaxCcUatten Max consecutive unit attention count exceeded
47—MaxCmdTmout Max Accumulated command timeout count
exceeded
50—DevStatus01 New state is DEAD
51—DevStatus02 Start device failed
60—Restart01 Failed restart
61—Restart02 Failed restart
62—Restart03 Failed restart
63—NewCfigFail Failed to start after writing new configuration
70—ScanSelTmo Bus scan: selection timeout
71—ScanMaxCc Bus scan: max check conditions exceeded
72—DevInsertFail Device insertion: failed to spin device
73—DevInsertOffl Device insertion: system drive went offline
74—UncfigDev01 Unconfigured device failed inquiry
75—UncfigDev02 Unconfigured device found
76—UncfigDev03 Unconfigured device found