Installation guide

Running a Device Rebuild

6-4 GAM Client v3.00 and WSAM User’s Manual

3. Click the Rebuild button in the Disk Device Information dialog box.

Rebuild runs and the Rebuild Status box appears (see the previous chapter).

Close the box and continue or leave the box open until Rebuild has

completed.

When rebuild has completed, the selected physical device AND the logical

drive(s) of which it is a part are returned to operational status. If you cancel

rebuild, the device returns to its offline (dead) status (red X), and the logical

drives that occupy this physical device all go to critical status (yellow

exclamation point). You must complete a future rebuild to return the physical

device and logical drive(s) to operational status.

1. Mylex External RAID Controllers perform rebuilds automati-

cally. You need only click the Rebuild button to restart a stopped

rebuild (and only on slot 0 if duplex).