Installation guide

External RAID Controller Operation Overview
4-66 GAM Client v3.00 and WSAM User’s Manual
Set Sequential
The Set Sequential button sets all logical drives to LUN assignments
sequentially and all host to logical drive mapping to Enable All Hosts. For
example, logical drive 0 to LUN 0, logical drive 1 to LUN 1, etc.
Clear All
The Clear All button sets all LUN assignments to None. You can then select
individual assignments more closely while allowing several assignments of
“inaccessible.”
 WARNING
DO NOT leave all assignments at None. This
indicates that no logical drives are accessible to
any port on any controller.
Restore
The Restore button resets the Host to LUN Mapping configuration to the
mapping that was assigned at the time RAID Assist was entered. If editing
an existing configuration, the original mapping is read from the firmware. A
new configuration reverts to the default mapping, Enable All Hosts.
Cancel
The Cancel button cancels the entire configuration, including what was set
up under the Disk Arrays, Logical Drives, and LUN Mapping tabs. If you
want to cancel only your LUN Mapping changes, use the Restore button.
Apply
The Apply button applies the entire External RAID Controller configuration,
including what was set up under the Disk Arrays, Logical Drives, and LUN
Mapping tabs.
Click Apply when you are ready to accept the entire External RAID
Controller configuration you’ve specified across all Manual Configuration
tabs.
There will be a confirmation message followed by a “Do You Want To
Reset?” message. Reset will take a couple of minutes.