Installation guide

IBBU Option
Manual Number 775012 A-3
3. Remove the protective pin cover and peel-off label from J1 on the
IBBU.
4. Leaving the 4 standoffs attached to the IBBU, remove a nylon screw
from the free end of each nylon standoff.
Figure A-3. Installing the IBBU
5. Install the IBBU so that J1 on the IBBU connects to J5 on the
DAC960PG/PJ. Pin 1 on the IBBU’s J1 must connect to hole 1 on the
DAC960PG/PJ’s J5. The mounting holes on the IBBU will line up with
the mounting holes on the DAC960PG/PJ if the connectors are plugged
in correctly.
6. Be sure the 4 standoffs line up with the 4 holes in the DAC960PG/PJ.
Place a nylon screw through a hole from the back of the DAC960PG/PJ
into a standoff, and turn the screw to the right until it is snug (not too
tight). Repeat this step with the remaining 3 standoff screws.
Nylon Screw
Standoffs