Installation guide

Installation
A-2 DAC960PG/PJ Installation Guide
Installation
Tools Needed
The only tool needed for the installation is a small, flat-blade screwdriver
Procedure
1. If the DAC960PG/PJ is not already removed from the system, power
the system down and then remove the DAC960PG/PJ.
, WARNING
Disconnect the system from the electrical wall
outlet before opening the system cabinet. Working
with the system covers off and power applied to the
system can result in shock and serious injury.
2. Remove the loopback plug from J5 on the DAC960PG/PJ. Keep the
loopback plug in a safe place, in case the IBBU needs to be removed at
a later time.
Figure A-2. Removing the Loopback Plug
Loopback Plug
J5
This mark on the
loopback plug must be
aligned with Pin1 on J5.
1
2
19
20
J5 Detail