Installation guide

Connectors and Jumpers
3-4 DAC960PG/PJ Installation Guide
External SCSI Connectors
The external connectors on the controller are female, Dual In-line Micro
SCSI connectors. Figure 3-3 shows the configurations that are available on
both the DAC960PG and the DAC960PJ.
Figure 3-3. Configurations of 1, 2, and 3 External SCSI Connectors
The corresponding cable connector that fits the controller is available from
AMP and from Honda. Part numbers for the Honda connector and hood are:
Connector – HDRA–E68MA1
Hood – HDRA–E68LGKPE
The AMP part number for the connector assembly (with offset hood and jack
screws) is:
Connector assembly – 787801-1
The correct offset hood and connector assembly is critical if cables are to be
connected to simultaneously to external channels 0 and 2 on the three-
channel version of the DAC960PJ. Proper alignment of the offset hood cable
assembly is shown in Figure 3-4.
A
B
C
DAC960PG
1-Channel
DAC960PG
2-, 3-Channel
DAC960PJ
2-Channel
DAC960PJ
3-Channel