Installation guide

Connectors and Jumpers
3-2 DAC960PG/PJ Installation Guide
External Channel Connectors
J5
JP4
JP5
I
nterna
l
Channel 0
Connector
I
nterna
l
Channel 1
Connector
I
nterna
l
Channel 2
Connector
J1 J2 J3
JP6
0
1
Connectors and Jumpers
Up to three Ultra SCSI channels are supported on the DAC960PG/PJ. The
SCSI connector locations are shown in Figure 3-1.
Be sure that the Jumper JP6 has a jumper installed (see Figure 3-1 and Table
3-1).
☛
Note
The half-card has only one SCSI channel. Its jumpers
are numbered differently than on the full size cards.
See Figure 3-2 and Table 3-2 for half-card connector
and jumper references.
Figure 3-1. Full-length Card Component Layout
Table 3-1. Full-length Card Jumper and Connector Descriptions
Component Description Default Setting
JP4 Connector for optional front panel LED harness –
JP5 Serial Port Connector –
JP6 Reserved Installed
J5 Intelligent Battery Backup connector – If an IBBU
is not installed, a loopback plug must be installed
in this socket.
Installed at
factory