Installation guide

Installation
Manual No. 771971 3-11
Terminating External Disk Arrays
If the all the SCSI devices on a channel are connected to the external
connector of a channel, the end of the SCSI bus farthest from the controller
must have a terminator installed.
The DAC960PG will automatically
enable
on board termination at its end of
the SCSI bus.
m
Caution
The external connector of the DAC960PG must only
be connected to the end of a SCSI bus, not anywhere
in between the ends, or proper termination cannot be
ensured.
Figure 3-4. External Disk Array, Single-ended SCSI Termination