Installation guide

Adapter and Device Configuration

Manual No. 3000863 3-13

Figure 3-11. Switch Settings Window

See Table 3-3 for a list of the switch settings and their values. Default values

are shown in

BOLD ITALIC TYPEFACE

Table 3-3. SCSI Device Configuration Parameter Settings

Option Value Description

SCSI ID 0-

Use this option if you need to change a SCAM

device’s SCSI ID on the SCSI bus. The

FlashPoint host adapter’s ID is set to 7 by

default.

Negotiated

Rate

Async

Sync 5 MB/s

Sync 10 MB/s

Sync 20 MB/s

This is the transfer data rate that the host

adapter will attempt to establish with the target

device.

Note

: If you experience a system hang

condition or data corruption, lower the

negotiated rate to attempt to remedy the

problem. If you are connecting an

Ultra SCSI device be sure to change the

negotiated rate to 20 MB/s.

Wide Negotiation

: -