Installation guide

Introduction
Manual No. 3000863 1-3
Hardware Requirements
Your PCI computer needs:
• One available PCI bus master expansion slot for each FlashPoint being
installed
• A 3.5" floppy drive
• DC power for internal SCSI drives or AC power for external
subsystems
You need the following cables:
• A 50-pin cable with a high-density connector to connect the
FlashPoint adapter to external devices
• A 50-pin, flat ribbon cable to connect internal SCSI devices to the
FlashPoint adapter (included with adapter kit)
• An optional cable to connect the drive activity LED on the host front
panel to the FlashPoint adapter
☛
Note
The device activity LED cable is usually supplied
with the host system.
The peripherals you are attaching to the FlashPoint adapter should be
SCSI-2 or SCSI-3 Common Command Set (CCS) compatible.