Installation guide

Manual No. 775020 Index-1
Index
A
Aborted Installation C-2
AcceleRAID 150
SCSI Interrupt Steering Logic
(SISL) 1-1
SISL (SCSI Interrupt Steering
Logic) 2-15
Standard PCI Bus 2-1
Alignment of Pin 1 and cables 2-3, 2-17
Anti-static bag 2-8, 2-22
Anti-static handling procedures 2-6,
2-20
Automatic circuitry 2-11, 2-25
B
BIOS disable or enable 3-2
BIOS geometry set to 2 GB 3-3
BIOS Options menu 3-1, 3-2
BIOS options sequence 3-1
C
Cable alignment 2-3, 2-17
Cable orientation 2-3, 2-17
Cable types 2-3, 2-17
Caching controller C-3
CD-ROM boot disable or enable 3-2
CD-ROM drive takes priority 3-2
Check termination 2-11, 2-25
Connecting SCSI cables 2-10, 2-24
Connectors, Jumpers, and LED’s 2-5,
2-19
Controller Board
Installation (SISL) 2-20
Installation (Standard) 2-6
Controller features
single-channel 1-3
wide Ultra2 SCSI RAID
LVD channel 1-3
D
DAC960PRL Block Diagram
(SISL) B-4
(Standard) B-3
Default BIOS geometry 3-3
Default for CD-ROM option 3-2
Disabled on-board termination 2-12,
2-25
Disposal of lithium battery/crystal
module 2-2, 2-16
Drive channel(s), SISL 2-25
Drive channel, Standard 2-11, 2-12
Drive geometries, 8GB or 2GB 3-3
E
EDO parity memory 60ns B-1
4MB B-1
Embedded system board channels 2-26
Enable 8 GByte or 2 GByte drives 3-3
Enable termination power 2-14, 2-28
Enabled on-board termination 2-11,
2-25
End device termination 2-11, 2-25
Environmental specifications
altitude B-2
form factor B-2
humidity B-2
MTBF (mean time between failure)
B-2
temperature B-2
Error messages
aborted installation C-2
drive check C-1
NVRAM error C-3
start-up C-1
system reboot or power down C-3
External connector 2-11, 2-25