Installation guide

Controller Installation (SISL)
2-22 AcceleRAID 150 Installation Guide
3. Remove the AcceleRAID 150 controller from the anti-static bag as
shown in Figure 2-18.
Figure 2-18. Remove Controller from the Anti-Static Bag
4. If Jumper 10 (JP10) is not in place, install it (ON position), as shown in
Figure 2-19, when using the AcceleRAID 150 with the SISL feature.
Figure 2-19. Install Jumper 10 (JP10) on two pegs – ON position
JP10