Technical information

How Do I Do a Custom Configuration?
2-28 RAID EzAssist User’s Manual
❑ Apply the Configuration to the Controller.
In order for the disk arrays and logical drives you set up to become a valid,
registered configuration, you must Apply the configuration to the controller.
☞ To apply the configuration, press Tab if necessary to switch
focus to the buttons, use the arrow key to select Apply, then
press Enter,
OR
☞ To cancel the configuration, press Tab if necessary to switch
focus to the buttons, use the arrow key to select Cancel, then
press Enter.
When you apply the new configuration, RAID EzAssist writes configuration
information to the Mylex controller and the drives. This takes a few
moments, so a message is displayed (Figure 2-27).
Figure 2-27. Writing RAID Configuration. Please Wait...
☞ Wait for the configuration information to be written to the
controller and the drives.
When the process is complete, RAID EzAssist brings you to the main menu.
When the main menu appears:
• Look in this chapter if you’ll be doing an additional configuration
activity.
• Refer to Chapter 3 if you’ll be doing controller configuration.
• Refer to Chapter 4 if you’ll be doing a monitoring or maintenance
activity, changing physical device SCSI properties (New Controllers
only), or adding drives (requiring a rescan for devices).
• Refer to Chapter 5 if you’ll be using any advanced options.
• To exit RAID EzAssist, see “How Do I Exit RAID EzAssist?” on page
2-67.