Technical information

How Do I Configure a Mylex Controller for the First Time?
1-10 RAID EzAssist User’s Manual
☛ Note
After viewing configuration details, press Enter to
select OK and return to the RAID Configuration
Summary screen.
☞ To apply the configuration, use the arrow key if necessary to
select Apply, then press Enter,
OR
☞ To cancel the configuration, use the arrow key to select
Cancel, then press Enter.
When you apply the new configuration, RAID EzAssist writes configuration
information to the Mylex controller. This takes a few moments, so a message
is displayed (Figure 1-6).
Figure 1-6. Writing RAID Configuration. Please Wait...
☞ Wait for the configuration information to be written to the
controller.
Next you’ll see a Configuration Status screen (Figure 1-7). Your automatic
configuration has been completed.
Figure 1-7. Configuration Complete - Reboot or Main Menu
Your next step will be to install the appropriate Mylex Disk Array Controller
driver for the operating system you’ll be using on the computer in which the
Mylex RAID Controller is installed.