Technical information

How Do I Change SCSI Transfer Properties for a Previous Mylex PCI Controller?
3-12 RAID EzAssist User’s Manual
☞ Press the + or - key to set the desired value,
OR
☞ Press Spacebar to display a box of available choices, use the
arrow key to select your desired value, then press Enter.
☞ Repeat the steps above for other controller channels if
necessary.
❑ View/Modify the Tag Queueing Setting.
Default = Yes
The Tag Queueing setting controls SCSI command tag queuing support for
each drive channel. This allows drives to work on multiple commands at the
same time. This function normally remains enabled (Yes). Disable (switch to
No) only when using older SCSI drives not supporting command tag
queuing.
☞ Use the arrow keys to select the Tag Queueing field for the
desired channel, then...
☞ Press the + or - key to set the value to Yes or No as desired,
OR
☞ Press Spacebar to display a box of available choices, use the
arrow key to select your desired setting, then press Enter.
❑ View/Modify the Bus Width Setting.
Default = Negotiated Value
In general it is not necessary to change this parameter since the controller
“negotiates” the supported data bus width.
However, if you do wish to change this setting...
☞ Use the arrow keys to select the Bus Width (8=Narrow,
16=Wide) field for the desired channel, then...