Technical information

Drive Configuration
Manual No. 775029 2-59
OR
☞ If you don’t want to disable spanning, use the arrow key to
select No, then press Enter.
❑ Build Disk Arrays.
☞ From the Custom Configuration menu, use the arrow key to
select Configure a New Disk Array, then press Enter
(Figure 2-60).
Figure 2-60. Select Configure a New Disk Array
The first step is to build at least two disk arrays with equal numbers of
drives. This is accomplished from the Disk Array Configuration screen
(Figure 2-61).
Figure 2-61. Disk Array Configuration Screen
This screen uses the following navigation strategy:
• PgDn and PgUp show you all the available or selected drives if there is
a small down/up-arrow beside the Unused Drives or Disk Array fields.
• Inside Unused Drives, arrow keys select a drive, Enter accepts the
highlighted drive and adds it to the Disk Array box to the right.
• The Tab key shifts control to the buttons, or from the buttons back to