Installation guide

NetWare
16 AcceleRAID 150/200/250 Quick Installation Guide
8. Change the path line to read:
A:\nw
and press <Enter>. NetWare scans for drivers on the floppy diskette in
the specified path.
9. In the “Select a driver to install” box, select the following driver:
MDAC.HAM | Mylex Disk Array Controller HAM Driver
10. Select Yes at the confirmation box to install the driver.
11. Press <Enter> to select the default server boot path.
12. Select Yes to save a backup of the old or existing driver.
13. Press <Enter> to continue when you see the message that the old
driver will be saved.
NetWare copies the file.
14. What you just backed up was the old or existing .DSK file. Repeat
Steps 12 and 13 for the .DDI file.
15. Select No to decline selection of an additional driver to install.
16. Exit INSTALL.NLM by pressing <Esc> three times, then selecting Ye s
at the “Exit Install?” box.
This concludes installation of the driver files needed to run your Mylex Disk
Array Controller under NetWare 4.11/4.2.
For more detailed information on operating system, driver installation, and
GAM Server, see the Disk Array Controller Software Kit Installation Guide
and User Manual (P/N 771929). To install the GAM client, refer to the
Global Array Manager Client Software Installation Guide and User Manual
(P/N 771961).