Installation guide

Using RAID EzAssist
4-6 AcceleRAID Installation Guide
☛
Note
If you want to do anything other than an automatic
configuration, refer to the RAID EzAssist
Configuration Utility User Reference Guide.
To perform a RAID configuration with the Automatic Configuration option
using RAID EzAssist, do the following:
1. Power on the computer. The AcceleRAID controller is furnished with
the BIOS enabled by default.
2. Watch the messages on the screen for the following prompt to be
displayed:
Press <ALT-M> for BIOS options
Wait approximately 5 seconds. Do not press any keys during this time.
☛
Note
If the BIOS has been disabled on the controller, You
will need to press Alt–M to enable it (See your
controller’s Installation Guide for details).
3. Watch the messages on the screen for the following prompt to be
displayed:
Press <ALT-R> for RAID Configuration options
4. Press
Alt–R
to get into RAID EzAssist (the configuration utility).
☛
Note
For more detailed information on how to run RAID
EzAssist, refer to the RAID EzAssist Configuration
Utility User Reference Guide (P/N 775029), which is
included on the distribution CDROM.