Installation guide

Performing a Standard Installation
3-4 AcceleRAID Installation Guide
Performing a Standard Installation
(AcceleRAID 250 only)
Figure 3-2. Removing JP10 on the AcceleRAID 250
m Caution
If an operating system or existing data resides on
SCSI disk drives already installed on the system, a
full backup must be performed on these drives prior to
this installation.
1. Be sure power is turned off and the system is not plugged into an
electrical outlet.
,
WARNING
To avoid electrical shock, do not attempt to
perform this hardware installation with power on.
Disconnect the system from the electrical wall
outlet.
2. If JP10 on the AcceleRAID 250 is installed, remove it, as shown in
Figure 3-2.
3. Plug the AcceleRAID 250 card into an available PCI slot
(see Figure 3-3).
Jumper on Jumper off
Jumper removed and
placed over a single
pin for safekeeping
12
3
JP4
JP5
JP10
J
1
Internal Connector
(68-Pin High Density)
Note: J1 and J2 are both on the same Channel.
J2
External
Connector
(VHDCI)
JP1